Installation of a Deployment Buckle Band
Let’s first put the spring bar of appropriate size into the band,
place the deployment clasp to where the buckle should be connected,
and then use the tool to press down, one by one,
the forked ends of the spring bar into the pin holes in the buckle. The buckle is now connected.
After that, we need to attach the band to the dial. Likewise, we recommend to install the band from the back side of the watch.
We insert the forked end of the spring bar into the watch lugs, use the tool to press down the other end and slide it into the other lug hole,and make sure the spring bar is installed tight.
This is a double-push deployment buckle. Gently push the button and the buckle stretches. Split it and insert the longer band.
We may try it on to find out the suitable hole in the band which fits the wrist, and then push the button on the buckle to fix the hole.
After that, insert the band into the buckle and fasten the band with the buckle.
It is also easy to dismantle the buckle. Just find the pin hole in the buckle, use the tool to press down the forked end in the pin hole, and the buckle will come off.
If we wish to remove the band, we’ll need to use the other end of the tool. Likewise, just locate the connection points between the spring bar and the lug hole, and use the spring bar tool to press down the connection points. The band can be easily removed as long as we hit the correct position.